Ondilo - Spa in line pH Sensor Kit for Connected Water Analyser - PPS-10660

Ondilo – Spa in line pH Sensor Kit for Connected Water Analyser

The Ondilo Spa in line pH sensor kit is a replacement sensor for the Ondilo Spa in line connected water analyser, used to monitor hot tub and pool water. It measures the pH of the water and comes with two calibration solutions and a calibration and sensor replacement guide.

Compatibility and use of the Spa in line pH sensor

This hot tub pH sensor is a spare part for the Ondilo Spa in line connected water analyser. It is intended for owners who monitor their spa or pool water with this analyser and need to replace the pH sensor.

Please note that this kit is the pH version. The Redox (ORP) measurement uses a different sensor, which is available separately as the Ondilo Spa in line ORP / Redox sensor kit.

What is included in the pH sensor kit

In addition to the sensor, the pack contains:

• 1 x pH 4 solution (20 ml)
• 1 x pH 7 solution (20 ml)
• 1 x calibration and sensor replacement guide

Fitting the replacement pH sensor

Attach the sensor to the “pH” slot on the manifold, following the instructions in the installation guide. Then connect the plug to the control box.

Calibration and sensor maintenance

After the first season, it is recommended to recalibrate the sensors each time you restart your pool or spa. If you do not winterise, recalibrate every 6 months. You should also recalibrate if you notice a drift in the measurements.

Documentation and Ondilo support

The quick start guide and the technical documentation can be downloaded below on this page.

For technical questions or after-sales service, Ondilo recommends contacting the manufacturer first through www.ondilo.com and the “Assistance” tab. Before you get in touch, have your UUID number ready. You will find it in the settings section of your ICO application or inside your Spa in line box.