American Products

American Products pool and spa jet parts

American Products is a name that pool and spa owners across Europe still come across when they open up an older installation and find a jet assembly, a fitting or a trim ring stamped with a part number that no longer matches anything in a current catalogue. Jets and their surrounding wall fittings are among the components that outlive almost everything else in a pool, which is why the demand for individual service parts continues long after a complete assembly has been superseded. Here you will find American Products service parts listed by their original part number, so an existing fitting can be matched rather than replaced in full.

What the Luxury Jet wall flange does

In a jet assembly, the wall flange is the part that sits against the pool or spa wall and forms the visible, watertight interface between the plumbing behind the shell and the jet internals in front of it. The body or housing is plumbed in and usually stays put for the life of the pool; the flange, the trim and the internal jet parts are the elements that are designed to be removed and serviced. The Luxury Jet wall flange (part number 47065700) is one of those serviceable pieces, which means a worn or damaged face can often be dealt with without touching the pipework.

Because the flange is the sealing face, it is also the part most exposed to chemical contact, UV light above the waterline and mechanical knocks from brushes, vacuum heads and bathers. Over time the plastic can become brittle or chalky, threads can distort, and the seal behind it can harden and lose compression.

Identifying the right part before ordering

Jet fittings from different ranges can look very similar from the front and still be completely incompatible behind the wall. A few checks will confirm whether a flange is the correct one:

• Part number — the original number, such as 47065700, is the most reliable reference. It is often moulded into the back of the fitting or printed on the original packaging or installation sheet.
• Exploded view and position number — service diagrams for jet assemblies number each component. Working out which position the flange occupies in the assembly prevents confusing it with a trim ring, an escutcheon or an eyeball holder.
• Measure the old part — note the outside diameter of the visible face, the diameter and form of the threaded section, and the overall depth from the wall face to the rear edge.
• Thread direction and form — some jet parts tighten clockwise and others anticlockwise, and thread pitch varies between ranges; check how the existing part came out.
• Seals and gaskets — if a flat gasket or O-ring sits behind the flange, measure its inside diameter and cross-section before reassembly rather than reusing a flattened one.

If a pool has been refurbished at some point, it is worth checking whether the jet in question is still the original fitting. Mixed assemblies are common in older installations, and the surrounding parts will tell you more than the pool’s age does.

Fitting and maintenance notes

Plastic jet fittings should be hand-tightened and then nipped up carefully; over-tightening is the single most common cause of cracked flanges and stripped threads. Clean the sealing face and the mating surface on the shell before fitting, and avoid petroleum-based lubricants on seals, as these can cause certain elastomers to swell. If the fitting is above the waterline on a spa, lowering the water level first makes the job far easier and avoids losing small parts.

During routine servicing it is worth turning jets by hand to check they still move freely, inspecting the flange face for hairline cracks, and confirming that the trim has not loosened. Catching a tired seal early usually means replacing one small component instead of chasing a leak behind the wall later.

American Products at PoolParthub.com

Here we list American Products service parts by their original part numbers, including the Luxury Jet wall flange 47065700, so owners of older pools and spas can source an exact replacement for a single component instead of rebuilding a whole assembly.

Spare parts for pools are bought to solve a specific problem, usually with the old part in hand. Listing them individually and by number keeps that straightforward: compare the number, check the measurements against the fitting you have removed, and order the one piece that needs replacing.