PolyMax - ICO Spa and ICO Pool Cap Gasket - PPS-10658

PolyMax – ICO Spa and ICO Pool Cap Gasket

This ICO Spa and ICO Pool cap gasket is a small replacement seal that provides a secure seal around the cover of the Ondilo ICO Spa v2 Essential+ connected water analyser and the ICO Pool. It is a compact ring-shaped part, so the exact measurements below are the most important thing to check before you order.

Compatibility with ICO Spa and ICO Pool

This cap gasket is intended for the ICO Spa and the ICO Pool. Its job is to make sure the cover of the unit is sealed securely, so it is the part to look at when the existing gasket on your analyser needs replacing.

If you need the cover itself rather than the gasket, that is a separate item: see the Cover for Ondilo ICO. This page covers the gasket only.

Gasket dimensions

The gasket has the following dimensions:

• Outside diameter: 88 mm
• Inside diameter: 84 mm
• Thickness: 2 mm

These figures describe a thin, small-diameter seal, so even a small difference in size will matter when you compare it with your current gasket.

How to choose the right replacement gasket

Before ordering, take the old gasket from your ICO Spa or ICO Pool and measure it. Compare the outside diameter, inside diameter and thickness with the values above. If all three match, this is the replacement cap gasket you are looking for.

Check the measurements rather than relying on appearance alone, because gaskets of similar looks can differ slightly in size and a seal that does not match will not sit correctly around the cover.

Replacing the cap gasket

When you replace the gasket, remove the old one completely and make sure it is not left behind in the groove or on the sealing surface. Then fit the new gasket so that it sits evenly around the cover before you close it.

A gasket that is missing, damaged or out of shape can no longer do its job as a seal, which is the main reason to replace it rather than reuse it.