Aqua-Flo - Drain Plug O-Ring for Flo-Master XP2, XP2e and XP3 Pumps - 92200060

Aqua-Flo – Drain Plug O-Ring for Flo-Master XP2, XP2e and XP3 Pumps

The Aqua-Flo 92200060 drain plug O-ring is a replacement spare part for the drain plug on Aqua-Flo Flo-Master XP2, XP2e and XP3 pumps, as well as the Circ-Master XP. It is a small, separate hot tub pump O-ring, so you can replace just the ring; the drain plug itself is listed separately.

Compatibility with Flo-Master and Circ-Master pumps

This O-ring is a spare part for some Aqua-Flo pump wet ends, such as the Flo-Master XP2 single-speed pump. The Aqua-Flo part number 92200060 is used on the following pumps:

• Flo-Master XP2
• Flo-Master XP2e (single or two-speed)
• Flo-Master XP3
• Circ-Master XP

If your spa has one of these Aqua-Flo pumps and you need a replacement drain plug O-ring, this is the part to look for.

O-ring dimensions

Before ordering, compare the size of the ring you are replacing with the measurements below. They are the dimensions of the Aqua-Flo 92200060 O-ring:

• Outside diameter: 18 mm
• Inner diameter: 13 mm
• Thickness: 2.5 mm

The ring is small, so measure carefully and, if possible, hold your old ring next to a ruler or calliper.

How to choose the right part

Start by identifying the pump fitted to your spa. Look for the model name, such as Flo-Master XP2, XP2e or XP3, or Circ-Master XP, and then match it against the list above. The manufacturer part number to look for is Aqua-Flo 92200060.

The XP2e is covered in both its single-speed and two-speed versions. If your pump is a different model that is not listed on this page, do not assume that this O-ring will fit it.

Drain plug sold separately

This listing is for the O-ring only. If the plug itself also needs replacing, the Aqua-Flo drain plug is available as a separate item. Ordering the two parts separately means you only buy what your pump actually needs.