Aller au contenu

Unités de contrôle

Control units: exploded views and spare parts

A control unit is the part of a pool installation that nobody looks at until something stops responding. It holds the electronics, the display or interface, the internal wiring and the housing that keeps all of it dry and protected. When a single component inside fails, the sensible repair is almost always to replace that component rather than the whole assembly — and for that you need to know exactly which item you are looking at. That is what the drawings in this section are for.

Here you will find exploded views and matching spare parts for Norsup control units of the Norsupone V2 type, listed per software or hardware revision so that the drawing you open matches the unit in front of you.

What an exploded view gives you

An exploded view is a technical drawing in which every component of an assembly is pulled apart along its axis and given a position number. Each number corresponds to an entry in the parts list below the drawing. Instead of describing a part in words — which rarely survives translation between a supplier, an installer and a customer — you simply quote the position number for the correct model and revision.

Using the drawing makes a difference in a few practical ways:

  • No guesswork on shape: you can see how the component sits in the housing and what it connects to before ordering.
  • Correct revision: parts are grouped per version, so a component that changed between revisions does not get ordered by mistake.
  • Full assembly context: the drawing also shows the screws, covers, seals and small fixings that are easy to forget until the unit is already open.
  • Clear communication: a position number plus the model designation is unambiguous for anyone handling the request.

The Norsupone V2 revisions

Three revisions of the Norsup Control Unit, type Norsupone V2, are covered here: V2.02, V2.03 and V2.04. They belong to the same family, but a manufacturer does not issue a new revision without reason. Between versions, a board layout can change, a connector can be relocated, a component can be sourced differently, or an internal part can be redesigned. Visually the units can look near identical from the outside, which is precisely why the revision matters when ordering.

Before you select a drawing, locate the exact designation on the unit itself. This is normally printed on a label or rating plate on the housing, or shown on the interface during start-up on units that display their version. Note the full string, including the figures after the decimal point, and open the matching exploded view. If the label is damaged or unreadable, compare the internal layout of your unit against the drawings of all three revisions before deciding — the position and shape of the internal components is usually enough to tell them apart.

Ce qui doit généralement être remplacé

Control units live in warm, humid plant rooms, and that environment dictates which components wear out first. In practice, replacement requests tend to concentrate on a limited number of items:

  • Display and interface parts: the user-facing element takes the most handling and is exposed to condensation.
  • Printed circuit boards: the heart of the unit, and specific to the revision in almost every case.
  • Housing components and covers: brittle plastic, broken clips and damaged cable entries after years of service.
  • Seals and gaskets: these keep moisture out of the enclosure and harden over time.
  • Small fixings: screws and mounting hardware that corrode or get lost during earlier servicing.

Always isolate the power supply before opening an enclosure, and leave work on wiring and electronic components to a qualified electrician where local regulations require it.

Control units at PoolParthub.com

Here we list the exploded views for the Norsupone V2 in revisions V2.02, V2.03 and V2.04, each with its own parts list, so that a repair can be prepared properly rather than by trial and error. The drawings sit alongside the rest of the exploded views on the site, which cover other assemblies in a pool installation in the same numbered format.

The aim is simple: one place where the model, the revision and the position number lead to the right component, so a working control unit does not have to be scrapped because of one failed part. If you cannot identify your version from the drawings, note down everything printed on the unit’s label before getting in touch.