Poolstar Freeflo filtration pump motor fan cover 0.55/0.75/1.10 kW - R0029

Poolstar Freeflo filtration pump motor fan cover 0.55/0.75/1.10 kW

This is the OEM plastic fan cover (shroud) that fits over the external cooling fan on the rear of the Poolstar Freeflo filtration pump motor. It channels airflow across the motor casing on the TEFC (Totally Enclosed Fan Cooled) motor, keeping the motor at a safe operating temperature during continuous filtration cycles. One cover serves the 0.55 kW, 0.75 kW, and 1.10 kW single-phase pump variants.

What this fan cover does in the Freeflo filtration pump

The Freeflo uses a TEFC motor design in which an external fan — not internal airflow — cools the motor body. The fan cover encloses that fan, directing air over the motor housing to dissipate heat and protecting the rotating fan blades from poolside debris, hose splashes, and physical contact. Without an intact cover, cooling airflow becomes uncontrolled and the fan itself is exposed to damage.

Which Freeflo models it fits

This cover is confirmed for the Poolstar Freeflo filtration pump range in the three single-phase power ratings listed: 0.55 kW (0.75 hp), 0.75 kW (1 hp), and 1.10 kW (1.5 hp). All three share the same rear-motor geometry, so a single cover part covers the full range. Verify your pump’s kW rating on the motor data label before ordering if you are unsure of your model.

Signs it needs replacing

Inspect the cover when you service the pump at the start of each season. A cracked, shattered, or missing fan cover exposes the spinning fan blades — a contact hazard — and allows uncontrolled airflow that reduces cooling efficiency, shortening motor life. You may also notice the motor running hotter than usual or see visible plastic fragments near the pump base after an impact.

How to install it

Isolate the pump from power at the breaker before starting. The cover typically clips or screws directly onto the rear motor bracket; remove any retaining screws or clips, pull the old cover away from the motor end, align the replacement over the fan, and refit the fixings. No special tools are required beyond a screwdriver, and the job takes under 10 minutes on a cold pump.