LX Pump Co. - WP300-II 2-Speed Hot Tub Pump with 2-Inch Unions - PPS-10684

LX Pump Co. – WP300-II 2-Speed Hot Tub Pump with 2-Inch Unions

The LX Whirlpool WP300-II is a 2-speed hot tub pump. The slow speed handles filtration and heating, while the fast speed runs the massage jets. This replacement spa pump delivers 2.2 kW (3.0 HP) on high speed and is also available in WP200-II oraz WP250-II versions with different motor powers.

WP300-II spa pump specifications

The WP300-II uses a two-speed motor, so you can run gentle circulation for filtration and heating and switch to full power for the jets.

• Power high speed: 2.2 kW (3.0 HP)
• Power low speed: 0.45 kW
• Maximum flow rate: 730 litres/minute
• Length 445 mm, width 202 mm, height 235 mm

Compare these dimensions with the space in your equipment bay before ordering.

Przyłącza, kabel i wtyczka

Outflow and intake have a male thread with a 78 mm outside diameter. The pump is supplied with unions and gaskets for 2-inch pipe (60 mm diameter).

Dostępny jest w wersji z fabrycznie podłączonym Wtyczka AMP (cable length 130 cm). Installations with a mini J&J plug need an adapter from AMP to mini J&J, sold separately. Alternatively, reuse the cable from your existing pump if it is in good condition.

Orientacja części mokrej i rodzaje zaślepek

The WP300-II pump is offered in several versions, so choose the one that matches your installation.

• Wet end orientation: standard exit, exit to left, exit to top left, exit to right, exit to top right
• Plug types: AMP plug, J&J plug, in.link plug

Part numbers and similar pumps

Other spa brands list this pump under the following numbers, which you can use to find the right replacement:

• Volition: 30WP
• Wellis: ACM0394
• Jazzi: JAPU11
• Watkins (HotSpring / Caldera): 0982801-03

The Koller 3 HP, Waterway Executive and Aqua-Flo Flo-Master XP2e pumps have the same motor power and thread size as the WP300-II, with roughly similar dimensions. If you swap to another model, check the available space and the fixing distances first, as pipe connection adjustments may be necessary.