Davey – O-ring do pokrywy pomp basenowych Silensor SLS – 403187
10,95 €
Tax Inc.
Wysyłka 1–3 tygodnie
Certyfikowany sklep internetowy
Łatwe zwroty w ciągu 14 dni
Szukasz porady?
Davey — Lid O-Ring for Silensor SLS Pool Pumps
Oryginalny o-ring pokrywy Davey do Silensor SLS series pool pumps. This is the seal that sits under the transparent pre-filter lid, keeping the strainer housing water-tight so the pump can prime and hold vacuum. If your pump is losing prime, drawing air, or leaking a fine spray around the lid rim, this O-ring is almost always the cause.
Do czego pasuje
- Davey Silensor SLS100E
- Davey Silensor SLS150E
- All SLS-variant Silensor pumps with the smaller pre-filter housing
Not compatible with SLL-variant Silensor pumps — those use a larger O-ring on the wider pre-filter housing (different part).
Replacement tips
- Depressurise the system first — turn the pump off, close any suction / discharge valves, and open the manual air-bleed on the filter.
- Clean the O-ring seat with a soft cloth before fitting the new seal — grit is the number-one reason new O-rings still leak.
- Apply a thin smear of silicone pool-lube (never petroleum grease — it swells the rubber over time).
- Inspect the seal annually; replace every 2–3 seasons or the moment you spot flat spots, cracks, or a permanent groove.
Genuine Davey OEM spare part — same seal Davey installs at the factory, guaranteed to match the housing dimensions exactly.
Informacje dodatkowe
| Waga: | 0,05 kg |
|---|---|
| Wymiary: | 10,0 × 10,0 × 1,0 cm |
| Marka: | Davey |
| Seria: | Silensor SLS |
| Typ części: | Oryginalna część zamienna Davey OEM |
| Modele pomp, z którymi urządzenie jest kompatybilne: | Silensor SLS100E, Silensor SLS150E |
| Niezgodne z: | Silensor SLL variants (larger pre-filter housing) |
| Location on pump: | Under the transparent pre-filter (strainer) lid |
| Materiał: | Nitrile rubber (NBR) — chlorine resistant |
| Funkcja: | Water-tight seal between lid and strainer housing |
Szczegóły
- Genuine Davey OEM part — exact dimensions, guaranteed fit against the factory housing
- Fixes the classic Silensor SLS symptoms: loss of prime, air bubbles in the strainer, fine spray leak around the lid
- Nitrile rubber — resistant to chlorine and standard pool water chemistry
- Tool-free swap — most owners can replace it in under a minute
- Fits SLS-variant Silensor pumps only — SLL variants need the larger housing O-ring (different SKU)
- Consumable wear part — plan to inspect annually and replace every 2–3 pool seasons
