Davey - Inel O pentru capacul pompelor de piscină Silensor SLS - 403187
10,95 €
tax inc.
Livrare 1–3 săptămâni
Certificat magazin online
Retururi ușoare în termen de 14 zile
Ai nevoie de sfaturi?
Davey — Lid O-Ring for Silensor SLS Pool Pumps
O-ring original Davey pentru capac, pentru Silensor SLS series pool pumps. This is the seal that sits under the transparent pre-filter lid, keeping the strainer housing water-tight so the pump can prime and hold vacuum. If your pump is losing prime, drawing air, or leaking a fine spray around the lid rim, this O-ring is almost always the cause.
Pentru ce este potrivit
- Davey Silensor SLS100E
- Davey Silensor SLS150E
- All SLS-variant Silensor pumps with the smaller pre-filter housing
Not compatible with SLL-variant Silensor pumps — those use a larger O-ring on the wider pre-filter housing (different part).
Replacement tips
- Depressurise the system first — turn the pump off, close any suction / discharge valves, and open the manual air-bleed on the filter.
- Clean the O-ring seat with a soft cloth before fitting the new seal — grit is the number-one reason new O-rings still leak.
- Apply a thin smear of silicone pool-lube (never petroleum grease — it swells the rubber over time).
- Inspect the seal annually; replace every 2–3 seasons or the moment you spot flat spots, cracks, or a permanent groove.
Genuine Davey OEM spare part — same seal Davey installs at the factory, guaranteed to match the housing dimensions exactly.
Informații suplimentare
| Greutate: | 0,05 kg |
|---|---|
| Dimensiuni: | 10,0 × 10,0 × 1,0 cm |
| Marcă: | Davey |
| Seria: | Silensor SLS |
| Tipul piesei: | Genuine Davey OEM spare part |
| Modele de pompe compatibile: | Silensor SLS100E, Silensor SLS150E |
| Incompatibil cu: | Silensor SLL variants (larger pre-filter housing) |
| Location on pump: | Under the transparent pre-filter (strainer) lid |
| Material: | Nitrile rubber (NBR) — chlorine resistant |
| Funcție: | Water-tight seal between lid and strainer housing |
În detaliu
- Genuine Davey OEM part — exact dimensions, guaranteed fit against the factory housing
- Fixes the classic Silensor SLS symptoms: loss of prime, air bubbles in the strainer, fine spray leak around the lid
- Nitrile rubber — resistant to chlorine and standard pool water chemistry
- Tool-free swap — most owners can replace it in under a minute
- Fits SLS-variant Silensor pumps only — SLL variants need the larger housing O-ring (different SKU)
- Consumable wear part — plan to inspect annually and replace every 2–3 pool seasons
