DAB - Pool pump EUROSWIM 100T 2" three-phase 380V - 7043972

DAB – Pool pump EUROSWIM 100T 2″ three-phase 380V

Rated at 1 HP (0.75 kW) and supplied at 380 V three-phase, the EUROSWIM 100T delivers up to approximately 23 m³/h at an 8 m head through standard 2″ female-threaded ports, making it a well-matched filtration pump for medium to large residential pools. The “T” three-phase configuration draws just 3.8 A, keeping running costs low while benefiting from a high-efficiency IE2 motor that operates noticeably more quietly than comparable single-phase units. Self-priming to 2 m without a check valve, it is ready to work in plant rooms where the pump sits above the water level.

Hydraulic performance & self-priming

The EUROSWIM 100T is a self-priming centrifugal pump with a built-in high-capacity pre-filter, capable of handling pool water up to 60 °C across a pH range of 6.5–8.4. The 2″ suction and discharge ports are reinforced with stainless steel ring nuts to resist both mechanical stress and chemical attack, and the pump will re-prime from up to 2 m static lift without needing a foot valve. Its hydraulic components are manufactured from glass-fibre reinforced technopolymer, providing a high-efficiency impeller that fully isolates the motor shaft from the pumped liquid.

Motore e impianto elettrico

The three-phase asynchronous motor runs in continuous duty (S1) at 380 V / 50 Hz, drawing only 3.8 A across all three phases. The motor housing is die-cast aluminium finished with a cataphoresis anti-oxidation treatment, and the entire assembly carries an IP55 protection rating with Class F insulation — suitable for outdoor plant rooms subject to moisture and airborne pool chemicals. Anti-vibration rubber feet are fitted as standard, keeping structure-borne noise to a minimum.

Pre-filter & salt compatibility

The large-volume pre-filter basket is enclosed by a transparent polycarbonate cover that resists oxidation over years of service, allowing the installer or pool owner to inspect debris levels at a glance without removing any fittings. The mechanical seal is constructed from carbon, alumina, NBR, and AISI 316 stainless steel — a combination that makes the EUROSWIM 100T fully compatible with saltwater pools and electrolytic chlorination systems without accelerated wear.