Maytronics Dolphin Supreme M5 diagnostic basic cable holder - 9982332

Maytronics Dolphin Supreme M5 diagnostic basic cable holder

This is the OEM cable holder for the Diagnostic Basic (DB) motor block unit fitted to the Dolphin Supreme M5. It locates and retains the power cable where it enters the motor block unit, preventing movement, strain, and chafing at the connection point during cleaning cycles.

What this cable holder does in the Dolphin

The cable holder clips around the power cable at the motor block unit entry point, locking it against the chassis so pull-forces from the cable in the water are absorbed by the holder rather than transmitted to the internal connector. Without a serviceable holder in place, repeated cable movement gradually stresses the internal wiring and can cause intermittent power loss or connector damage.

Sur quels modèles Dolphin est-il compatible ?

This holder is shared across the entire Diagnostic Basic platform. Confirmed models include the Supreme M3, Supreme M5, DX3, DX4, DX5, DX6, Nautilus, Apollo, Endeavor, Atlantis, Triton, Edge, Discovery, Saturn, Orion, and Orion II. Always verify your model before ordering — the part number 9982332 is the definitive cross-reference.

Signes indiquant qu'il faut le remplacer

Inspect the holder if you notice the cable moving freely at the robot body rather than sitting firmly in position, if the plastic clip shows cracking or deformation, or if the cable entry point shows scuff marks from cable friction. A broken holder is also the first thing to check when a cable connector fault is diagnosed — mechanical damage at the entry point is a common precursor.

Comment l'installer

Open the motor block unit cover, release the old holder from its seat, and press the replacement into position until it clicks. No tools are required for the holder itself; access to the MBU cover may require removing two or three screws with a Phillips screwdriver. Total time is under five minutes.