Bombes de calor
Heat pump exploded views and spare parts
An exploded view is the fastest way to order the right component for a pool heat pump. Instead of guessing at a description, you work from the drawing for your exact model, read the position number next to the part and order against that reference. Here we list the exploded views for the pool heat pumps in the AstralPool programme, including the PM40 series and the Mr Perfect range, so that fans, sensors, switches, boards and casing parts can be matched to the unit standing beside the pool rather than to a generic equivalent.
Which models are covered
The range is built around two families. The PM40 units are listed by their internal designation, which distinguishes between the MD and TD builds as well as between the original refrigerant versions and the R32 versions. Because an R32 unit and its predecessor can share a casing but differ in refrigerant circuit components, the drawings are kept separate.
- PM40 MD series — MD1, MD2, MD3, MD4, MD5, MD7 and MD8, with MD7 also listed in an R32 version.
- PM40 TD series — TD7, TD8 and TD12, with TD12 also listed in an R32 version.
- Mr Perfect — listed by heating output, from the 9 kW unit up through 17, 22, 27, 32 and 41 kW.
- Reference codes — each drawing carries its own article code, such as WH000418 or SC966, which is useful when passing an enquiry on.
Finding your model before you order
Start at the rating plate, usually fixed to the side or rear panel of the outdoor unit. It carries the model designation and the serial number, and that designation is what the exploded view is indexed on. On the Mr Perfect units the output in kilowatts is the key identifier, so a 22 kW cabinet and a 27 kW cabinet are treated as different machines even where they look similar from the front.
Once you are on the correct drawing, note the position number of the part you need rather than its name alone. Several components repeat around a heat pump — grommets, screws, panel clips, small sensors — and the position number is what separates them. Where a part is a seal, an O-ring or a flexible connector, measure the old one before ordering: internal diameter, outside diameter and thickness, taken with a calliper on a part that has been allowed to cool and relax, will confirm the match. For hydraulic unions, check the thread and the pipe size at the inlet and outlet before assuming that a replacement set is the same as the original.
Parts that wear out first
Pool heat pumps run long hours through the season in a damp, outdoor environment, and failures tend to cluster around the same components. Knowing which group a fault belongs to makes the drawing much quicker to read.
- Fan assembly — fan motor, fan blade, motor bracket and the protective grille, all exposed to weather and vibration.
- Electrical and control — control board, display or keypad, contactor, capacitor and the wiring harness that links them.
- Sensing and safety — water and air temperature sensors, defrost sensor, flow switch and high and low pressure switches.
- Hydraulic side — inlet and outlet unions, O-rings, condensate drain fittings and the connections to the heat exchanger.
- Cabinet — front, side and top panels, evaporator fin guards, feet and fixings, which take the brunt of corrosion and accidental damage.
Work involving the sealed refrigerant circuit — compressor, reversing valve, expansion device and the gas side of the exchanger — should be left to a qualified refrigeration engineer, and national rules on handling refrigerants apply.
Bombes de calor a PoolParthub.com
Here you will find the exploded views for the AstralPool PM40 and Mr Perfect heat pumps gathered in one place, with the drawing codes listed so that a part can be traced from the diagram to the order without a detour through generic catalogues.
Keeping these views together means an installer or pool owner can identify a fan motor, a sensor or a panel for a specific output and build variant, rather than ordering something that nearly fits. If the model designation on the rating plate is unclear, send the plate details and the serial number and the right drawing can be pointed out.