Davey - Moteur d'entraînement Silensor / SilensorPro avec arbre cannelé (nouvelle génération) – SLS100E / SLS150E / SLL150E - S75SM-1

Davey – Silensor / SilensorPro Service Motor with Splined Shaft (New Generation) – SLS100E / SLS150E / SLL150E

The S75SM-1 is a genuine Davey replacement service motor assembly for new-generation Silensor and SilensorPro pool pumps. Featuring a splined shaft and matching splined-groove interface, it is the correct motor unit for new-generation SLS100E, SLS150E, and SLL150E pump variants. It is typically fitted when the original motor fails due to bearing wear, winding failure, or loss of performance after extended service.

Compatibilité

This service motor is designed exclusively for new-generation (splined shaft) variants of the Davey Silensor SLS100E, SLS150E, and SLL150E pool pumps. It is not suitable for older “-0” generation models, which use a different shaft interface. Always verify your pump’s generation before ordering — check your pump’s label or service documentation to confirm the splined-groove design.

Pourquoi l'authenticité est importante

Davey designs and manufactures the motors for its Silensor pumps in-house, ensuring each unit meets the precise tolerances required for the water-cooled motor housing. A genuine Davey service motor guarantees correct fitment, maintains the pump’s quiet operation, and preserves any remaining warranty or service centre support. Non-genuine alternatives may not match the splined shaft geometry or thermal characteristics of the original.

Installation

Motor replacement on the Silensor range is a workshop-level service task. Davey’s official service documentation notes that specialist Silensor service tools (part numbers 13810SP and 13810-1SP) are required to remove the case nuts during servicing. It is strongly recommended to have this part fitted by an authorised Davey Pool Equipment Service Centre to ensure correct assembly and safe electrical reconnection.