AstralPool - Elite Connect CellGuard® LS pH 12 Salt Chlorinator – 12 g/h - 77408

AstralPool – Elite Connect CellGuard® LS pH 12 Salt Chlorinator – 12 g/h

The AstralPool Elite Connect CellGuard® LS pH 12 is a low-salt salt chlorinator with pH control included, producing 12 g/h of chlorine for pools up to 50 m³. It works at a salt level of 1-2 g/L, draws 0.6 A and has a cell life of 18,000 h.

How the chlorinator works

Elite Connect CellGuard® LS pH is a salt chlorinator for low-salt pools. Once salt has been dissolved in the pool water, the electrolysis cell passes an electric current through titanium plates (electrodes), and free chlorine is produced as the salt water flows through. Chlorine is made while the pool’s recirculation system, pump and filter, is running.

The patented CellGuard® technology cleans the electrodes automatically. It uses pH injection to remove limescale and keep the plates clean, which keeps day-to-day maintenance of the cell low. pH control is included in this range.

Production modes and pool control

Chlorine output can be set to suit the pool, with production modes for normal use, boost, covered pool and biopool. The unit is described as an intelligent, evolutionary chlorinator that also controls other pool equipment from one device.

Four digital inputs and four output relays let you configure the filter pump, heating, lighting and other equipment. Built-in timers allow programming of all pool functions.

Touchscreen and connectivity

The control panel has a colour TFT touchscreen. Integrated Wi-Fi and Bluetooth connectivity gives access to pool information in the manufacturer’s app, so the unit can also be adjusted remotely.

Control functions can be extended with optional plug-in S-Driver modules:

• redox (ORP) control
• free chlorine control
• variable-speed pump control

Built-in safety and monitoring

A gas sensor and a flow switch are fitted as standard. The unit raises alarms if there is no water flow or the cell is not fully flooded, and also reports when the electrode reaches the end of its life.

Instalación y conexión

Installation, electrical connection and maintenance must be carried out by a qualified installer who has read the full manual. The unit runs on 230 V – 50/60 Hz and must be powered through a residual current device and be earthed.

The cell connects to glued PVC pipes of Ø 63/50 mm, and installation in a by-pass is recommended. The maximum pressure is 1 kg/cm². Install the equipment upright on a rigid surface in a dry, well-ventilated area, away from flammable materials and never in an area at risk of flooding.

Maintenance and cell life

With CellGuard® electrodes, cell life is up to 18,000 h under normal conditions. Keep the pool water balanced as set out in the manual, and check and calibrate the sensors and peristaltic pumps as described in the full manual.