Maytronics Dolphin E10, cabo azul de 2 fios, 12 m (sem articulação) - 99958902-DIY

Maytronics Dolphin E10 blue 2-wire cable 12 m (no swivel)

This is the genuine Maytronics replacement blue communication cable for the Dolphin E10 and a range of compatible above-ground robotic pool cleaners. Measuring 12 m (40 ft) in length with a 2-wire DIAG configuration and no inline swivel, it carries power and basic motor signalling between the power supply and the cleaner’s motor unit. The pre-moulded DIY motor-side connector makes this a plug-in replacement that requires no soldering, no crimping, and no specialist tools.

Function and cable specification

The 2-wire DIAG cable transmits low-voltage power and motor control signals from the power supply unit down to the cleaner. Unlike the 3-wire DYN (dynamic) cables fitted to higher-specification Dolphin models, this 2-wire build carries no remote-control or wireless communication signal — it is the correct specification for the entry-level E10 platform and its close relatives. The 12 m length gives the cleaner full freedom of movement in pools up to approximately 8 × 4 m.

Modelos Dolphin compatíveis

This cable is a direct OEM replacement for Dolphin robotic pool cleaners that left the factory with a 12 m, 2-wire, no-swivel cable. Confirmed compatible models include the E10, Escape, S50, Active 10, T15, Echo, Proteus DX3, and the Nautilus CC (99996153-US). Always verify your model’s original cable specification — wire count and the presence or absence of a swivel — before fitting this part.

Symptoms that indicate the cable needs replacing

Common failure signs include the cleaner stopping mid-cycle without any fault code on the power supply, intermittent loss of power to the motor unit, visible jacket cracking or stiffness (typically caused by prolonged UV or chemical exposure), a kink that cannot be straightened, or water ingress at either end of the cable causing corrosion at the connector pins. If the power supply tests healthy and the motor unit itself is confirmed functional, a degraded cable is the most likely culprit.

Why genuine Maytronics matters

Third-party cables frequently use an inferior jacket compound that becomes brittle in chlorinated or salt water and fail to replicate the tolerances of the pre-moulded motor-side connector. A poorly seated connector can cause intermittent faults that are difficult to diagnose and, in worst cases, moisture ingress into the motor unit. The genuine Maytronics 99958902-DIY uses the same marine-grade jacket and precisely moulded plug as the original factory-fit cable, ensuring the connector seats correctly and the jacket resists chemical degradation over time.