Kripsol – Koral szivattyútartó (alap) a KS / KSE és Ondina sorozatokhoz – ‭500100090001‬

Kripsol Koral pump support (base) for KS / KSE and Ondina series

This is the genuine OEM pump support — the moulded base bracket that locates and anchors the Kripsol Koral pump body to its mounting surface, keeping the hydraulic and motor assembly in correct alignment under continuous operation. It corresponds to positions 18 and 48 in the official Kripsol KS / KSE exploded-parts diagram, supplied as a set of one support plus six fixing feet.

What this pump support does in the Koral

The support forms the structural base of the pump unit. It absorbs vibration from the motor, prevents lateral movement of the pump casing, and distributes the weight of the wet end evenly across the mounting surface. Without a sound support, the pump body rocks under load, stressing the casing flange and accelerating seal wear.

Melyik Koral modellekhez illeszkedik?

Part 500100090001 is listed in Kripsol’s official spare-parts catalogue for the entire Koral KS and KSE range — KSE 33 M through KSE 300 — and for the Ondina series (Ondina 33 M, 33 T, 51 M, 71 M, 71 T, and 300 M). Check your pump’s model label before ordering; the support does not interchange with the Ninfa NK or Kapri families.

Jelek, amelyek arra utalnak, hogy cserére szorul

Look for cracked or stress-whitened legs, rubber feet that have compressed flat or detached entirely, and any visible flex in the pump body when the motor starts. If the pump walks across its pad during priming or leaves scuff marks on the plinth, the support has lost structural integrity and must be replaced before the vibration damages the mechanical seal.

Hogyan kell telepíteni?

Isolate the power supply and close the suction and return valves before starting. Unscrew the hardware kit (ref. 500139420100) securing the pump to the support, lift the pump body clear, swap the support, then refit and torque the fasteners evenly in a cross pattern. The six feet press into the underside sockets without adhesive; seat them fully before reinstalling the pump on its plinth. Total bench time is around 20 minutes with a standard spanner set.