Profec - Pipe bracket steel galvanised 108–114 mm M8/M10 2-piece - 0329459

Profec – Pipe bracket steel galvanised 108–114 mm M8/M10 2-piece

Sized to accept pipes in the 108–114 mm outer-diameter range, this Profec 2-piece bracket is designed for secure, noise-attenuating pipe support in solar heating, HVAC, and plumbing installations. The galvanised steel shell pairs with an EPDM rubber seal lining that cushions the pipe, dampens vibration, and meets DIN 4109 sound-insulation requirements — all while accepting either M8 or M10 threaded rod, giving the installer flexibility on site.

Konstruktion und Korrosionsbeständigkeit

The bracket body is manufactured from steel with a hot-dip galvanised surface treatment, delivering robust protection against moisture and the outdoor conditions common to rooftop solar collector pipework or plant-room installations. The EPDM seal insert is resistant to ageing, ozone, and UV exposure, ensuring long-term elasticity and a firm, rattle-free grip on the pipe over the full service life of the system.

Safety closure & DIN 4109 compliance

As a 2-piece design, the bracket wraps fully around the pipe and closes with a secure safety latch, preventing accidental opening once installed. Conformance to DIN 4109 confirms that the EPDM lining provides the acoustic insulation required for structurally transmitted sound, making this bracket equally suitable for indoor plant rooms where noise propagation through building fabric must be controlled.

Threaded-rod compatibility

The female thread is machined to accept both M8 and M10 threaded rod without an adaptor, covering the two most common suspension rod sizes used across European solar, heating, and water-supply pipework. This dual compatibility simplifies specification and means the bracket can be retrofitted into existing installations regardless of which rod size is already in use.