Kripsol - Impulsor/turbina da bomba K-FLO 2,00 HP - 500100070010

Kripsol K-FLO pump impeller / turbine 2.00 HP

This is the genuine OEM impeller (turbine) for the Kripsol K-FLO pump at the 2.00 HP power rating, covering the Koral and Mini Kapri pump families. The impeller is the rotating hydraulic heart of the pump: it converts motor torque into water flow, drawing water through the pre-filter housing and pushing it through the filtration circuit under pressure.

Qual é a função deste impulsor na bomba K-FLO?

Seated on the motor shaft inside the pump volute, the impeller spins at 2,850 rpm and generates the head pressure that drives water around the pool circuit. A worn or chipped impeller reduces flow rate, increases motor temperature, and forces the pump to work harder against the same hydraulic resistance. Replacing it with this OEM part restores designed flow performance immediately.

A que modelos K-FLO se adapta

This impeller is rated for the 2.00 HP variant of the Kripsol K-FLO pump series, which sits within the broader Koral and Mini Kapri pool pump family. Always confirm your pump’s power rating on the motor nameplate before ordering — the K-FLO range spans multiple horsepower variants and each has its own impeller geometry.

Sinais de que precisa de ser substituído

The clearest indicators are a drop in return-jet pressure with the motor running at normal speed, a pump that struggles to prime, louder-than-usual cavitation noise from the pump housing, or visible cracking and erosion on the impeller vanes when you open the volute. Sand ingestion and dry-running are the most common causes of impeller wear on this pump family.

Como instalá-lo

Isolate the pump electrically and close the isolation valves before opening the pump. Remove the volute screws, pull the volute clear, and unscrew the impeller from the motor shaft — it is typically right-hand threaded, so hold the shaft steady and turn the impeller anticlockwise. Fit the replacement by hand-tightening clockwise, reassemble the volute with a new o-ring if the existing one shows any compression set, and re-prime before restarting the motor.

Por que é que o Kripsol genuíno é importante

The K-FLO impeller is hydraulically matched to the pump’s diffuser and volute geometry. An off-specification impeller — even one that physically fits the shaft — will shift the pump’s operating curve, reducing flow at the design duty point and potentially overloading the motor. Using the genuine Kripsol part guarantees the impeller vane profile, bore tolerance, and material grade are identical to the factory component.