Description
Zodiac CyclonX brushes RAL9022 pack of 2 R0633100
The Zodiac CyclonX brushes RAL9022 (reference R0633100) are original sheet style rubber brushes for Zodiac CyclonX pool cleaning robots.
Supplied as a pack of two, they replace the worn brushes on the two drive rollers of the cleaner so that it regains grip on the pool surface
and restores its original cleaning performance.
Key features of the Zodiac CyclonX brushes
- Original Zodiac spare part for CyclonX series electric pool cleaners.
- Sheet style rubber brushes in grey RAL9022 for efficient debris pick up.
- Pack of two brushes, one for each roller of the pool robot.
- Designed to provide strong adhesion on liner and similar smooth surfaces.
- Helps the robot climb walls and clean the waterline more effectively.
Technical specifications
- Brand: Zodiac
- Series: CyclonX
- Manufacturer reference: R0633100
- Colour: Grey RAL9022
- Part type: Sheet style rubber brushes for drive rollers
- Set contents: 2 brushes (one per roller)
- Recommended pool surfaces: Liner and smooth finishes
- Alternative for tiles: PVA brush kit recommended for gresite or very smooth tiles.
Compatibility with Zodiac pool robots
These RAL9022 brushes are used on many Zodiac CyclonX models and related robots that share the same drive roller design.
They are suitable as a direct replacement when the original brushes have the same sheet pattern and colour.
- Zodiac CyclonX RC4300 and RC4380.
- Zodiac CyclonX RC4400 and RC4402.
- Other CyclonX and RC or RX models that specify reference R0633100.
Always check the exploded view or spare part list for your specific cleaner model and confirm that the brush reference is R0633100.
If the part number and brush design match, this set is the correct replacement.
When to replace the Zodiac CyclonX brushes
Brushes on a pool cleaning robot wear gradually due to contact with the pool floor, walls and waterline.
Worn brushes reduce traction and can cause the cleaner to slip, lose climbing ability or leave dirt behind.
- Replace the brushes when the sheet edges are rounded, torn or significantly thinned.
- Replace the brushes if the robot struggles to climb walls or does not reach the waterline.
- Replace the brushes if the cleaner slides on the floor or frequently loses grip.
- Inspect the brushes at the start and end of each season for visible wear or deformation.
Installation and maintenance guidelines
- Disconnect the power supply from the control unit before handling the pool robot.
- Remove the cleaner from the water and place it on a soft surface to avoid scratching the casing.
- Release the worn brushes from the drive rollers according to the steps in the user manual.
- Clean the rollers and check that there are no sharp edges or debris that could damage the new brushes.
- Fit the new Zodiac CyclonX brushes R0633100, ensuring that the sheet pattern faces the correct direction.
- Press the brushes fully into place along the entire roller length so they sit securely and evenly.
After installation, run a short cleaning cycle and visually confirm that the robot moves smoothly, climbs walls correctly and that the new brushes
maintain full contact with the pool surfaces. Rinse the brushes with fresh water after intensive use to help reduce chemical stress and extend their lifetime.
