Description
White skimmer lid and frame 8080
The white skimmer lid and frame 8080 is a replacement cover set for pool skimmers, designed to renew the visible top section around the
skimmer opening. By replacing a discoloured or damaged lid and support frame, this set restores a clean white look at deck level and
helps protect the skimmer body beneath from dirt and mechanical impacts.
Overview and typical use
Over time, skimmer lids and frames can fade, crack or deform due to UV radiation, changes in temperature and regular foot traffic around
the pool. The white skimmer lid and frame 8080 is intended as a like for like replacement to restore both safety and appearance in the
skimmer zone of residential pools.
This set is typically installed on concrete or tiled decks where the skimmer body is built into the pool wall and connected to the
filtration system. Only the upper frame and removable cover are exchanged, so there is no need to intervene in the hydraulic circuit.
Design and materials
The white skimmer lid and frame 8080 is normally manufactured from robust UV resistant plastic engineered for outdoor use. The material
is chosen to withstand exposure to sunlight, rain, chemically treated pool water and normal loads from people walking around the pool.
- White surface that blends with most coping stones and light coloured decks.
- Textured top side to provide grip for wet, bare feet around the pool edge.
- Frame that supports the lid and transfers loads to the surrounding deck.
The removable lid provides quick access to the skimmer basket and any dosing equipment placed in the skimmer throat, simplifying routine
maintenance tasks.
Compatibility and dimensions
The reference 8080 identifies a specific skimmer lid and frame format. For a correct fit, the replacement set should be matched to the
original skimmer model and to the dimensions of the existing opening in the deck. Using the proper reference avoids gaps, rocking or
excessive play between the frame, lid and surrounding paving.
- Designed as a replacement for skimmers that accept the 8080 frame size.
- Frame typically drops into or is fixed to the surrounding deck structure.
- Lid sits flush with the frame for a neat, low profile finish at deck level.
Before ordering, measuring the clear opening and outside frame size is recommended to verify that the 8080 format corresponds to the
installed skimmer.
Installation guidelines
Fitting the white skimmer lid and frame 8080 can usually be completed during routine maintenance with basic hand tools. In most cases,
work can be carried out without lowering the pool water level, as the intervention is limited to the deck surface around the skimmer.
- Remove the existing lid and carefully lift or unscrew the old frame.
- Clean the support surface to remove mortar residues, dirt and loose material.
- Position the new frame, checking level and alignment with the surrounding coping.
- Fix the frame according to the skimmer manufacturer’s instructions.
- Place the new lid in the frame and check that it sits flat and stable underfoot.
After installation, people should be able to walk over the lid without noticeable rocking or noise, and the cover should remain easy to
lift for access to the skimmer basket.
Maintenance and service life
Once installed, the white skimmer lid and frame 8080 requires only basic care to maintain its appearance and function. Routine visual
checks help identify early signs of wear or damage in areas with heavy use or strong sun exposure.
- Clean the lid surface periodically with a soft brush and mild detergent.
- Avoid harsh solvents or abrasive pads that could scratch or dull the plastic.
- Inspect for cracking, warping or excessive discolouration at the beginning of each season.
Replacing a damaged skimmer lid promptly helps prevent accidents around the pool, keeps the skimmer opening protected from large objects
and maintains a neat, consistent finish along the pool edge.
