Description
Meytec conductivity calibration solution – 1.413 mS/cm – bottle 250 ml
The Meytec conductivity calibration solution 1.413 mS/cm bottle 250 ml is a reference liquid for calibrating and checking conductivity and tds meters used in pools, spas and general water treatment. With a defined conductivity of 1.413 mS/cm at the reference temperature, it allows you to adjust electronic probes so that day to day measurements remain accurate and comparable over time.
Use of 1.413 mS/cm conductivity solution
Conductivity and tds meters gradually drift as electrodes age and are exposed to treated water and temperature variations. Calibrating with Meytec conductivity calibration solution 1.413 mS/cm corrects this drift in the low to medium conductivity range typically encountered in fresh water applications, including swimming pools and spa fill water.
This value is commonly used as a standard point for many portable and bench conductivity meters, making it easier to compare readings from different instruments and to verify that sensors still respond correctly after prolonged use.
250 ml bottle format for regular calibration
The Meytec conductivity calibration solution 1.413 mS/cm bottle 250 ml is supplied in a practical screw cap bottle designed for frequent calibration and verification work. The 250 ml volume offers enough solution for many checks while remaining easy to handle and store in technical rooms or service vehicles.
- 250 ml of ready to use 1.413 mS/cm conductivity standard.
- Design bottle with secure cap for repeated opening and closing.
- Suitable for handheld meters, inline controllers and bench instruments.
To preserve the specified value as long as possible, only a small working volume should be poured into a clean container for each calibration, and the main bottle must be closed immediately after use.
Calibration with Meytec conductivity solution
The Meytec conductivity calibration solution 1.413 mS/cm bottle 250 ml is compatible with most conductivity and tds meters that accept external calibration standards. It is suitable for residential and commercial pools, spas and other water systems where conductivity is used as a control or diagnostic parameter.
- Reference point at 1.413 mS/cm for conductivity and tds meters.
- Supports accurate adjustment of sensors in fresh water applications.
- Useful for regular verification of inline probes used in control systems.
Always follow the calibration procedure specified by the meter manufacturer, including any instructions on temperature compensation and stabilisation time. Many instruments allow you to enter the reference value directly so the meter compensates automatically for temperature differences.
Example calibration procedure
Although details vary between devices, a typical calibration using Meytec conductivity calibration solution 1.413 mS/cm follows a few simple steps. This example describes a single point calibration in the low to medium conductivity range.
- Rinse the conductivity probe with demineralised water and shake off the excess.
- Pour a small amount of 1.413 mS/cm solution into a clean container.
- Immerse the probe in the standard, ensuring that the measuring cell is fully covered.
- Wait for the reading to stabilise and adjust the meter to 1.413 mS/cm according to the instructions.
Once the meter has been calibrated, rinse the probe again before returning it to normal measurement so that no standard solution enters the system being monitored.
Storage and handling recommendations
To keep the Meytec conductivity calibration solution 1.413 mS/cm bottle 250 ml within specification, it should be stored in a cool, dry place away from direct sunlight and heat sources. Good handling practices reduce contamination and extend the useful life of the solution.
- Always close the bottle tightly immediately after dispensing.
- Use only clean glass or plastic containers for the working volume.
- Never pour used standard back into the original bottle.
Combined with regular calibration, correct probe cleaning and proper storage, this Meytec conductivity standard helps keep conductivity and tds measurements stable and reliable for pool and water treatment applications.
