Fluidra - 2½" Pipe Gasket for PTK Arm Sand Filter

Fluidra – 2½” Pipe Gasket for PTK Arm Sand Filter

This is a genuine Fluidra replacement gasket for the 2½” pipe connection on the PTK Arm Filters series — commercial-grade, vertical fibreglass and polyester sand filters. It provides a pressure-tight seal at the relevant port or manifold connection, preventing leaks and maintaining filtration efficiency in the system.

Compatibility

This gasket is a direct spare part for the Fluidra PTK Arm Filters range with a 1000 mm filter bed, covering tank diameters of Ø650 mm, Ø800 mm, and Ø950 mm. Always cross-reference your filter’s assembly diagram or part number before ordering to confirm this is the correct gasket for your specific connection point.

Why Genuine Matters

Fluidra genuine gaskets are manufactured to exact dimensional tolerances for the PTK filter range, ensuring a reliable seal under the operating pressures of commercial pool filtration systems. An incorrectly sized or inferior aftermarket gasket risks seepage, pressure loss, and premature failure — using an OEM part protects both the equipment and the pool environment.

Installation

Shut down and depressurise the filter system fully before replacing the gasket. Inspect the mating surfaces for damage or debris, fit the new gasket dry or with a suitable lubricant as recommended, and reassemble the connection to the correct torque. A leak-check at start-up is strongly advised.