Tubo a pressione PE100 SDR17 160 mm × 9,5 mm liscio 10 bar nero/blu DVGW 12 m - 7023750

Pressure Pipe PE100 SDR17 160mm × 9.5mm Plain 10 bar Black/Blue DVGW 12m

Rated to 10 bar operating pressure at 20 °C and supplied in full 12-metre straight lengths, this 160 mm OD PE100 pressure pipe is built for large-bore water infrastructure — from commercial pool plant rooms and pump manifolds to underground mains supply and bulk water transfer. The 9.5 mm wall thickness delivers the balanced SDR17 dimension ratio that underpins its PN10 rating, while DVGW approval confirms compliance with German and broadly recognised European drinking-water and pressure-pipe standards.

Prestazioni relative al materiale e alla pressione

Manufactured in PE100 high-density polyethylene, the pipe achieves a minimum required strength (MRS) of 10 MPa, giving it excellent long-term resistance to internal pressure, crack propagation, and slow crack growth. The black body with co-extruded blue stripe provides UV stability in exposed above-ground runs whilst signalling potable-water suitability for below-ground installations — a distinction that matters on larger civil and pool infrastructure projects.

Jointing & installation

Plain (spigot) ends make this pipe compatible with the full range of PE100 jointing methods: butt fusion, electrofusion, and mechanical compression or push-fit couplings. The rigid 12-metre stick format suits straight trench runs or above-ground pipe bridges where minimal joints are preferred, reducing potential leak points across long distribution circuits connecting plant rooms, heat pumps, or filtration banks.

Sizing & application guidance

At 160 mm OD, this is a large-diameter pipe intended for high-flow commercial or public pool plant rooms, water parks, irrigation headers, and site mains. It is not suited to domestic above-ground installations without proper pipe supports and should be joined and pressure-tested by a qualified installer familiar with PE fusion or mechanical coupling techniques.