Aller au contenu

Hanna Instruments Saddle Clamp Injector for Ø63 mm Pipe, for BL10x/BL12x/BL13x (BL120-263)

Hanna Instruments BL120-263
1-2 semaines
32,45 € impôts inc.
Expédition Expédition 1-2 semaines
Certifié Certifié boutique en ligne
Retours faciles Retours faciles dans les 14 jours
Question Cherchez-vous des conseils ?
Posez votre question

Hanna Instruments saddle clamp injector for Ø63 mm pipe, for BL10x/BL12x/BL13x (BL120-263)

The BL120-263 is a saddle clamp injection point that lets a Hanna Instruments dosing pump feed chemical into a Ø63 mm PVC pressure pipe. It clamps around the pipe over a drilled hole and provides a threaded port for the injector or injection valve, so no pipework has to be cut or re-glued. It is used with the BL10x, BL12x and BL13x dosing pump families found in commercial pool water treatment installations.

Avec quoi ça va ?

Designed for Ø63 mm rigid PVC pipe used on pool circulation and dosing lines. It is intended for use with Hanna Instruments BL10x, BL12x and BL13x series dosing pumps and their standard injection valves. Pipe diameter is fixed, so check the outside diameter of your line before ordering.

Position de montage

Fit the saddle clamp on the pressure side of the circulation pump, downstream of the filter and after any heater, so dosed chemical is carried away and diluted immediately. Depressurise and drain the line, drill the pipe to suit the saddle port, then clamp the two halves around the pipe with the gasket seated and tighten evenly. Mount it on the top or side of a horizontal pipe run to avoid gas pockets and to keep the injector clear of sediment.

Durée de vie

The clamp body and gasket are wear items exposed to concentrated chlorine or acid at the injection point. Inspect the seal at each service interval and replace if you see weeping, crazing of the plastic or hardening of the gasket. Also replace after any over-tightening or if the pipe wall around the drilling shows stress cracks.

Remarques concernant la commande

Sold individually as a saddle clamp injection point, not as a complete dosing kit. The injection valve, non-return valve and dosing tubing are ordered separately if not already fitted. Order one clamp per chemical being dosed, and keep separate injection points for acid and chlorine at a safe distance apart.

Informations complémentaires

Référence produit : BL120-263
Diamètre du tuyau : Ø 63 mm
Compatibilité : BL10x / BL12x / BL13x dosing pumps
Utilisation : Chemical dosing injection on PVC pressure pipe
Marque : Hanna Instruments
Type de produit : Saddle clamp injection point
Vendu sous le nom de : Unité unique

En détail

  • No pipe cutting or re-gluing required
  • Direct fit on Ø63 mm PVC pipe
  • Compatible with BL10x, BL12x and BL13x pumps
  • Simple clamp-and-tighten installation
  • Only suits Ø63 mm pipe, no adapters
  • Injection valve and tubing sold separately
  • Requires drilling and depressurising the line