Description
Meytec conductivity calibration solution – 1.413 mS/cm – bottle 60 ml
The Meytec conductivity calibration solution 1.413 mS/cm bottle 60 ml is a low range reference liquid for conductivity and TDS meters used in pools, spas and general water treatment. With a defined conductivity of 1.413 mS/cm at the reference temperature, it allows you to calibrate probes so that daily measurements remain accurate and comparable over time.
Application and measurement range
Conductivity and TDS meters gradually drift as electrodes age and are exposed to treated water and temperature variations. Calibrating with Meytec conductivity calibration solution 1.413 mS/cm corrects this drift in the low to medium conductivity range typically found in fresh water and pool fill water. This reference point is widely used by portable and bench meters as a standard calibration value.
Regular calibration with a defined standard helps you detect sensor ageing early and ensures that changes in the displayed conductivity reflect real changes in water quality rather than instrument drift.
Compact 60 ml bottle for field use
The Meytec conductivity calibration solution 1.413 mS/cm bottle 60 ml is supplied in a compact screw cap bottle, ideal for test kits and mobile service cases. The smaller volume is well suited for occasional calibration of one or a few instruments, keeping the solution fresh until it is used.
- 60 ml of ready to use 1.413 mS/cm conductivity standard.
- Space saving bottle for field technicians and pool operators.
- Practical format for residential and small commercial installations.
For best results, only the amount needed for a single calibration should be poured into a separate clean container, keeping the remaining solution in the closed bottle.
Calibration with Meytec conductivity solution
The Meytec conductivity calibration solution 1.413 mS/cm bottle 60 ml is compatible with most conductivity and TDS meters that accept external calibration standards. It is suitable for handheld meters, inline controllers and multi parameter instruments that monitor fresh water, pool make up water or low salinity circuits.
- Reference point at 1.413 mS/cm for low to medium conductivity checks.
- Supports accurate adjustment of sensors in fresh water applications.
- Useful for routine verification of inline probes used in control systems.
Calibration should always follow the procedure described in the meter manual, including the use of temperature compensation and a sufficient stabilisation time before adjustment.
Example single point calibration
A typical single point calibration with Meytec 1.413 mS/cm solution is straightforward and can be integrated into regular maintenance. The aim is to align the meter reading with the known standard value.
- Rinse the conductivity probe with demineralised water and shake off excess drops.
- Pour a small amount of 1.413 mS/cm solution into a clean container.
- Immerse the measuring cell completely in the calibration solution.
- Wait for the reading to stabilise and adjust the meter to 1.413 mS/cm according to the instructions.
After calibration, the probe should be rinsed again before returning it to normal measurement so that the standard solution does not enter the system being monitored.
Storage and handling recommendations
To keep the Meytec conductivity calibration solution 1.413 mS/cm bottle 60 ml within specification, it should be stored in a cool, dry place away from direct sunlight and heat sources. Careful handling reduces contamination and helps maintain the stated value for as long as possible.
- Always close the bottle tightly immediately after dispensing.
- Use only clean glass or plastic containers for the working volume.
- Never pour used calibration solution back into the original bottle.
Combined with regular calibration, correct probe cleaning and proper storage, this Meytec conductivity standard helps keep low range conductivity and TDS measurements stable and reliable in pool and water treatment applications.
