Description
Zodiac Cyclonx floating cable 15 m R0632100
The Zodiac Cyclonx floating cable 15 m (reference R0632100) is the original power and signal cable for Zodiac Cyclonx electric pool cleaners.
It is designed to provide a safe and reliable connection between the cleaner and its power supply while remaining buoyant on the water surface to
reduce tangling and friction during cleaning cycles.
Key features of the Zodiac Cyclonx floating cable
- Original Zodiac spare part for Cyclonx series pool cleaning robots.
- Floating design that keeps the cable on or near the water surface during operation.
- Fifteen metre cable length suitable for typical private pool dimensions.
- Integrated three pin connector for direct connection to the cleaner head.
- Includes float elements to support neutral buoyancy and smoother cable handling.
- Robust insulation and jacket designed for permanent contact with pool water.
Technical specifications
- Brand: Zodiac
- Series: Cyclonx
- Manufacturer reference: R0632100
- Part type: Floating power and signal cable
- Cable length: 15 m
- Connector type (robot side): Three pin plug with sealing interface
- Function: Power supply and control signal transmission between robot and transformer.
Compatibility with Zodiac pool robots
This floating cable is designed for Zodiac Cyclonx and related electric pool cleaners that use a 15 m floating cable with three pin connector.
It is suitable as a replacement when the original cable has cuts, insulation damage or connector problems.
- Zodiac Cyclonx RC4300.
- Zodiac Cyclonx RC4350.
- Zodiac Cyclonx RC4360.
- Zodiac Cyclonx RC4370.
- Zodiac RC4100 and RC4130 models using the Cyclonx style cable.
- Zodiac RX4350 and RX4450 where specified by the manufacturer.
- Zodiac Cyclonx OC3300 Tile and OC3400 models using a 15 m floating cable.
Always confirm the reference R0632100 in the exploded view of your cleaner or on the label of the original cable before ordering.
If your current cable carries the same part number and uses a three pin connector with similar geometry, this spare part is the correct replacement.
When to replace the Zodiac Cyclonx cable
The floating cable is exposed to mechanical stress, sun and pool chemicals throughout the season.
Typical signs that a replacement is needed include visible cuts or cracks in the outer jacket, deformation or corrosion around the connector,
intermittent power loss, or robot stopping during operation when the cable is moved.
- Replace the cable if the insulation is damaged or shows deep cracks.
- Replace the cable if the three pin connector shows burnt pins or a loose fit.
- Replace the cable if the cleaner stops or resets when the cable is flexed.
- Inspect the full length regularly in areas that rub against edges or coping stones.
Installation and handling recommendations
- Disconnect the power supply from the mains before working on the robot or cable.
- Unplug the old cable from the power supply unit and from the robot head, following the locking mechanism indicated in the manual.
- Check the sealing surfaces and O rings around the robot connector and replace if they are damaged.
- Connect the new Zodiac Cyclonx floating cable to the robot until the three pin plug is fully engaged and locked.
- Connect the other end to the transformer or power supply, then carefully lay the cable on the water surface without tight coils.
- After installation, start a test cycle and verify that the robot operates without interruptions and that the cable moves freely.
For longer cable life, always unwind the full length before each cleaning cycle, avoid sharp bends and store the cable in wide loops in a shaded area
when the cleaner is not in use.
