Fluidra - Collector Assembly with Support Ø125 mm – 1800 mm

Fluidra – Collector Assembly with Support Ø125 mm – 1800 mm

This is the genuine Fluidra collector assembly with support bracket, sized for the 1800 mm lateral length and Ø125 mm connection, designed for use inside large-diameter commercial sand filters. The collector sits at the base of the filter tank and gathers filtered water from the lateral arms, channelling it out through the filter outlet while ensuring even water distribution across the full filter bed during both filtration and backwash cycles.

Compatibility

This assembly is a factory spare part for the Fluidra Volcano Filter range in tank diameters from Ø1050 mm to Ø2000 mm. Always verify your filter’s model number and tank diameter before ordering, as Fluidra produces similar collector assemblies in different lateral lengths and connection sizes to suit each tank diameter variant.

Why genuine matters

An OEM Fluidra collector assembly ensures precise dimensional fit within the tank, correct slot sizing on the laterals for effective sand retention, and full compatibility with the support bracket and centre hub. Aftermarket alternatives may compromise filtration efficiency or cause sand bypass, which can damage downstream equipment.

Installation

The collector assembly should be installed by a qualified pool technician. The unit connects centrally inside the filter tank and the integral support bracket holds it securely in position during operation and backwash. Always depressurise and isolate the filter system before any internal work, and inspect all lateral arms and the centre hub for wear while the tank is open.