Fluidra - Atlas Sand Filter Base Ø750 mm

Fluidra – Atlas Sand Filter Base Ø750 mm

This is the genuine Fluidra replacement base section for the Atlas reinforced polyester sand filter in the 750 mm diameter size. It forms the lower half of the filter tank, providing the structural foundation that supports the sand bed, houses the bottom collector manifold, and anchors the entire unit to the plant-room floor. It is an essential structural spare for restoring a damaged or cracked Atlas Ø750 filter body to full working condition.

Compatibility

This base is designed exclusively for the Fluidra Atlas sand filter with a tank diameter of 750 mm. The Atlas range is also produced in Ø500, Ø600, and Ø900 mm sizes — bases for those variants are not interchangeable with this part. Always verify your filter’s diameter before ordering.

Why Genuine Matters

The Atlas filter tank is built from polyester resin and fibreglass, engineered to withstand continuous operating pressures. A genuine Fluidra base section guarantees the correct wall thickness, flange geometry, and material specification to maintain a pressure-tight joint with the upper filter body — something aftermarket alternatives cannot reliably ensure.

Installation

Fitting a replacement filter base is a significant workshop task that involves draining and decommissioning the filter, separating the two tank halves at the sealed and reinforced joint, and re-bonding or re-bolting the new base to the upper body. Professional installation by a qualified pool technician is strongly recommended to ensure a safe, leak-free result.