Pressure Pipe PE40 25 mm × 2.7 mm Plain 6 bar Black 500 m - 0700015

Pressure Pipe PE40 25 mm × 2.7 mm Plain 6 bar Black 500 m

Supplied as a full 500-metre coil, this PE40 polyethylene pipe combines a 25 mm outer diameter with a 2.7 mm wall thickness to deliver a 6 bar working pressure — sufficient for pool plant-room supply lines, backwash runs, and general water-distribution duties. The plain (plain-end) format keeps it compatible with a wide range of standard compression and push-fit fittings used across European pool and irrigation installations. Rated to a maximum continuous temperature of 35 °C, it is well suited to unheated or lightly heated pool-side pipework.

Material & coil format

Manufactured from low-density polyethylene (PE40), the pipe is inherently corrosion-resistant, chemically inert to chlorinated water, and flexible enough to navigate changes in direction without additional bends — a practical advantage when running long underground or surface-mounted supply lines. The black colouring provides UV stabilisation, making it suitable for above-ground runs as well as buried applications. At 500 metres per coil this is a trade/contractor quantity intended for larger projects, pool-complex builds, or distribution stockholding.

Pressure performance & connections

The 6 bar pressure rating comfortably exceeds the typical 1–3 bar dynamic pressures seen in residential and light-commercial pool circulation systems, giving a useful safety margin. Plain ends allow the installer to choose the most appropriate jointing method for the application — compression fittings, barbed push-on connectors, or heat-fusion — without being committed to a proprietary coupling system. Standard PE compression fittings sized for 25 mm OD pipe connect directly with no adaptor.

Sizing to your installation

At 25 mm OD (approximately 19.6 mm internal diameter with a 2.7 mm wall), this pipe is commonly used for branch supply lines, filter-bypass loops, and backwash discharge on residential and small-commercial pools. It pairs naturally with 1″ or ¾” pool fittings via appropriate compression reducers where needed. The 500 m coil length suits contractors who wish to cut to precise lengths on site, minimising waste and reducing the number of joints in the finished installation.