Motor monofazic Poolstar Freeflo Racer de 0,55 kW - R0022

Poolstar Freeflo Racer single-phase motor 0.55 kW

This is the genuine Poolstar replacement motor for the Freeflo Racer filtration pump, rated at 0.55 kW on a single-phase supply. It is the driven heart of the pump assembly — when it fails, the impeller stops turning and water circulation ceases entirely. This motor is specific to the Freeflo Racer mono-block pump platform and is not interchangeable with other pump families.

Ce face acest motor în modelul Freeflo Racer

The motor provides the rotational force that drives the impeller inside the pump volute, pulling water from the pool through the pre-filter basket and pushing it on through the filtration circuit. Running at 0.55 kW on a single-phase 230 V supply, it operates within the mono-block housing where the motor and hydraulic end share a common shaft — meaning motor alignment is fixed at the factory and carries straight over to the replacement unit.

La ce modele Freeflo Racer se potrivește

This motor fits the full Freeflo Racer filtration pump range: FFL-031, FFL-051, FFL-071, FFL-101, and FFL-151. Confirm your pump model label before ordering — the motor is not rated for three-phase installations or higher-output variants outside this series.

Semne care indică faptul că trebuie înlocuit

The clearest indicator is a pump that hums briefly then trips the breaker, pointing to a seized or shorted winding rather than a mechanical blockage. You’ll also notice the motor running significantly hotter than normal to the touch at the end-cap, or emitting a burnt smell after a short runtime. A motor that starts but delivers sharply reduced flow — with the impeller and pre-filter confirmed clear — typically has a winding fault reducing torque output.

Cum se instalează

Isolate the pump from mains power and drain the volute before starting. The motor separates from the hydraulic end by unbolting the through-bolts at the pump bracket — the impeller unscrews from the shaft (left-hand thread on most Freeflo variants, so turn clockwise to release). Seat the mechanical seal correctly on the new motor shaft before reassembly; reuse the existing seal only if it shows no wear or scoring. Reconnect the terminal block wiring to match the original configuration, restore power, and prime the pump before running.

De ce este important să alegi produse originale Poolstar

The Freeflo Racer motor is a commonly copied component — aftermarket units routinely differ in winding resistance, shaft diameter tolerance, and thermal cutout rating, causing misalignment with the mechanical seal housing and premature seal failure. A genuine Poolstar motor carries the correct shaft spec and thermal protection profile to match the FFL-series hydraulic end exactly, protecting the pump body from consequential damage.