This is the genuine Astralpool decorative trim ring (embellecedor) designed to finish the face of the return fitting nozzle code 75778 in liner pools. It seats flush against the pool wall surface, concealing the raw cut edge of the liner around the nozzle aperture and giving the installation a clean, finished appearance. At 119 mm outer diameter and 9 mm depth it is sized precisely to the 75778 nozzle body \u2014 no trimming or adaptation required.<\/p>\n
The trim ring is the outermost visible component of the return fitting assembly. It clips or screws over the front face of the nozzle body, pressing the liner flat against the wall flange and preventing water from tracking behind the fitting. Without it, the liner edge lifts over time and the nozzle face looks unfinished. Replacing a cracked or discoloured ring restores both the watertight seal at the wall face and the visual finish of the fitting.<\/p>\n
This ring is confirmed to fit the Astralpool liner pool return fitting nozzle code 75778 only. The 75778 is a standard ABS wall-mount return nozzle for liner pools with an outer 2\u2033 thread. Do not fit this ring to any other nozzle code \u2014 the diameter and clip geometry are specific to this body. If you are unsure of your nozzle code, check the stamping on the back of the existing nozzle body before ordering.<\/p>\n
Inspect the trim ring if you notice the liner pulling away from the nozzle face, if the ring is visibly cracked or chalked from UV exposure, or if the beige colour has faded unevenly and is detracting from the pool finish. Chlorinated water accelerates surface degradation on ABS when the stabiliser breaks down; replacement is straightforward and does not require draining the pool beyond the nozzle height.<\/p>\n
Lower the water level below the return fitting. Remove the existing trim ring by unscrewing or unclipping it from the 75778 nozzle body. Press or thread the new ring onto the nozzle face until it seats fully against the liner and wall flange. Check that the liner is lying flat beneath the ring’s inner edge before refilling. No adhesive or sealant is required \u2014 the ring’s geometry provides the mechanical retention and face seal.<\/p>","protected":false},"excerpt":{"rendered":"