Maytronics Dolphin Supreme M5 – standardowa szczotka z PVC, szara – 6101635

Maytronics Dolphin Supreme M5 PVC brush grey standard

This is the genuine Maytronics OEM PVC brush (part 6101635) for the Dolphin Supreme M5 and a wide range of compatible dual-motor Dolphin models. It wraps around the robot’s wheel tube and provides direct scrubbing contact with the pool floor, walls, and waterline on every cleaning cycle. Two halves clip together around each wheel tube; a full set of four halves covers both brush rollers.

What this PVC brush does in the Dolphin

The brush sits on the rotating wheel tube and sweeps debris into the suction path while simultaneously scrubbing pool surfaces. The flexible PVC bristle sheet wraps flush against the tube via six interlocking tab-and-hole clips, holding it firmly in place throughout the cleaning cycle. Without a serviceable brush in contact with the pool surface, scrubbing efficiency drops and debris pickup degrades noticeably.

Do których modeli Dolphin pasuje

This brush is confirmed to fit a broad range of dual-motor Dolphin cleaners: Supreme M5, DX5, DX5S, DX6, M400, M500, C3, C4, C5, Oasis Z5, Oasis Z5i, Apollo Plus, Sigma, Triton Plus (old), Evolution X5, Pro X2, Wave 60, Wave 75, Wave 80, Wave 100, Aquarius XL, Nautilus CC, and Edge. Always verify your model before ordering — brush tube diameter varies across Dolphin generations.

Oznaki, że należy go wymienić

Inspect the brush if you notice reduced scrubbing lines on the pool floor after a run, or if the robot leaves visible dirt streaks rather than clean passes. Worn PVC teeth lose their profile and no longer grip the surface properly. Cracked, missing, or deformed tabs that no longer lock the brush to the wheel tube are a clear replacement trigger — a loose brush can foul the drive mechanism.

Jak to zainstalować

Release the old brush halves by pressing the tab extensions back through their locking holes and sliding the sheet off the wheel tube. Align the new brush sheet around the tube, press each tab through the corresponding hole on the opposite edge until it clicks, and confirm the brush sits flush with no gaps. No tools are required; the swap takes under five minutes per roller.