This is the genuine Fluidra filling cap designed to fit over the internal diffuser tube of the Atlas sand filter during the sand-loading procedure. It acts as a temporary protective plug \u2014 blocking the open top of the diffuser so that sand poured into the filter vessel cannot enter and damage the internal pipework or laterals. Compatible with diffuser tubes in both 2″ and 2\u00bd” sizes, it covers the full Atlas filter range.<\/p>\n
This filling cap is a dedicated spare part for the Fluidra Atlas reinforced polyester sand filter series, which is available in tank diameters from \u00d8500 mm to \u00d8900 mm. It fits diffuser tubes with a 2″ or 2\u00bd” connection. If you are unsure of your diffuser tube size, consult the exploded-view diagram for your specific Atlas filter model before ordering.<\/p>\n
Using an authentic Fluidra part guarantees a precise fit on the diffuser tube, ensuring a proper sand-tight seal during loading. A poorly fitting aftermarket cap risks allowing sand grains past the diffuser into the lateral assembly, which can cause blockages, reduced flow, or premature wear \u2014 problems that a correctly fitted genuine cap entirely prevents.<\/p>\n
Before loading sand, remove the upper diffuser cap that ships with the filter and replace it with this filling cap. Fill the tank with water to the halfway point, then pour in the required quantity of sand. Once loading is complete, remove the filling cap and reassemble the diffuser tube in reverse order, ensuring all sealing surfaces are clean and free of sand grains before closing the filter.<\/p>","protected":false},"excerpt":{"rendered":"