This is the genuine Fluidra replacement pressure gauge for the Baracuda WT2 sand filter (\u00d8600 mm, 1\u00bd” connections). Rated to 3 kgf\/cm\u00b2 (approximately 3 bar \/ 43 psi), it screws directly into the filter head via a standard 1\/8″ threaded port and gives an at-a-glance reading of the pressure inside the filter tank. Monitoring filter pressure is essential for knowing when to backwash and for detecting blockages or pump issues before they cause damage.<\/p>\n
This pressure gauge is a factory-specified spare part for the Fluidra Baracuda WT2 sand filter with a \u00d8600 mm tank and 1\u00bd” pipework connections. Always cross-reference your filter’s model number and existing gauge thread size before ordering to confirm fitment. It may also suit other Fluidra\/Astral filter heads sharing a 1\/8″ gauge port, but compatibility beyond the Baracuda WT2 \u00d8600 is not guaranteed.<\/p>\n
Aftermarket gauges often use lower-grade bourdon tube mechanisms that lose calibration accuracy over a single season, giving false readings that lead to unnecessary backwashing or, worse, missed over-pressure events. A genuine Fluidra part is manufactured to the same tolerances as the original, ensuring reliable readings throughout its service life and preserving the integrity of your filter warranty.<\/p>\n
Replacement is straightforward: relieve system pressure, unscrew the old gauge from the 1\/8″ port on the filter head, apply PTFE thread tape to the new gauge’s male thread, and hand-tighten followed by a quarter-turn with a spanner. Restart the pump and check for leaks before returning the system to normal operation. If you are unsure about working on a pressurised system, engage a qualified pool technician.<\/p>","protected":false},"excerpt":{"rendered":"