This is the genuine Fluidra replacement O-ring that seats under the pre-filter cap of the Perfom Plus ECO VS variable-speed pool pump (single-phase, 1.10 kW). It forms the critical watertight seal between the strainer pot body and its lid, preventing air ingestion and water leaks that would impair pump prime and performance. Replacing a worn or damaged O-ring is one of the quickest and most cost-effective ways to restore a leak-free, fully primed pump.<\/p>\n
This O-ring is designed specifically for the Fluidra Perfom Plus ECO VS pump in the single-phase 1.10 kW variant. Always cross-reference your pump’s model label and the Fluidra spare parts exploded-view diagram before ordering, as similar-looking O-rings from other pump families may differ in diameter or cross-section and will not seal correctly.<\/p>\n
Genuine Fluidra O-rings are manufactured to precise dimensional tolerances and from pool-chemical-resistant elastomer compounds, ensuring a reliable, long-lasting seal under the pressure and temperature cycles of continuous pool filtration. Aftermarket substitutes can swell, shrink, or harden prematurely, leading to recurring leaks and potential pump damage.<\/p>\n
Before fitting, switch off the pump and release any system pressure. Remove the old O-ring, clean the groove thoroughly, and apply a thin layer of silicone lubricant (never petroleum-based grease) before seating the new ring. Hand-tighten the pre-filter cap \u2014 no tools required \u2014 then check for leaks on restart. The job typically takes just a few minutes and requires no specialist skills.<\/p>","protected":false},"excerpt":{"rendered":"