This is the genuine Poolstar (Pentair) union fitting kit for the Freeflo Racer filtration pump range. Sized at 1\u00bd” (\u00d850 mm), it provides the threaded disconnect interface between the pump volute and the pool’s PVC plumbing lines on both the suction and discharge ports. When the original union fittings crack, leak, or seize, this kit restores a secure, serviceable connection without cutting pipe.<\/p>\n
A union fitting creates a semi-permanent, pressure-tight seal between the pump housing and fixed PVC pipework that can be broken and remade without cutting or re-gluing. Install one union on the suction port and one on the discharge port; thereafter, you remove the pump for basket cleaning, seal replacement, or winterisation by hand-turning the union nuts \u2014 no pipe saw required. The included O-rings are the primary sealing element, so their condition directly determines whether the joint holds pressure.<\/p>\n
This kit is confirmed for the Pentair Freeflo Racer filtration pump range, covering models FFL-031, FFL-051, FFL-071, FFL-101, and FFL-151. All of these pumps use a standard 1\u00bd” (\u00d850 mm) port thread, and this kit is the OEM-specified plumbing interface across the entire Freeflo line. Verify your pump model label before ordering if you have an earlier or atypical variant.<\/p>\n
Water weeping from the union collar during pump operation is the clearest failure signal \u2014 usually caused by a flat-spotted or chemically degraded O-ring, or a union nut that can no longer be tightened sufficiently because the thread has stripped or the body has cracked. If you find white calcium scale packed into the thread face and the nut will not fully seat even after cleaning, replace the kit rather than risk a pressurised leak. Discolouration and brittleness in the union body after several seasons of UV exposure also warrant replacement.<\/p>\n
Isolate the pump from mains power and close the isolation valves on both ports before starting. Unscrew the existing union nuts by hand or with a strap wrench \u2014 do not use pipe grips, which will crack the collar. Fit the new tail-piece adaptors to the pump ports and glue the corresponding slip sockets into the existing PVC pipework using pool-grade solvent cement; allow full cure time before pressurising. Seat the O-rings, hand-tighten the union nuts, then give each a quarter-turn with a strap wrench to achieve a firm, leak-resistant seal. Apply a pool-safe silicone lubricant to the O-rings before assembly to extend their service life.<\/p>","protected":false},"excerpt":{"rendered":"