Rated to 30 bar and 120 \u00b0C, this solid-brass hose tail adaptor converts a 1″ BSP male thread to a 32 mm hose tail in a compact 55 mm overall length \u2014 making it equally at home on pool pump outlets, filter manifolds, and heat-pump pipework where a reliable thread-to-hose transition is needed. The hefty 34 mm spanner flat allows secure tightening without distorting the body, ensuring a leak-free joint even under sustained system pressure.<\/p>\n
Machined from solid brass, the body resists corrosion in treated pool water and withstands continuous operating temperatures up to 120 \u00b0C \u2014 well above anything encountered in domestic or commercial pool plant rooms. The 30 bar pressure ceiling provides a generous safety margin over the typical 3\u20136 bar found in pool circulation systems, making this adaptor suitable for heating circuits and pressurised chemical-dosing lines as well.<\/p>\n
One end carries a 1″ BSP male thread that screws directly into any standard female-threaded pump port, filter valve, or manifold. The opposite end presents a 32 mm ribbed hose tail sized to accept standard 32 mm flexible hose, which is the most common bore used for domestic and semi-commercial pool pipework. The straight, in-line geometry keeps installation tidy and avoids unnecessary flow restriction.<\/p>\n
At just 55 mm long and with a 34 mm spanner flat, the fitting is easy to torque up in confined equipment-room spaces. A PTFE-tape or liquid-thread sealant applied to the male thread is all that is required for a watertight joint. Compatible with pool pumps, sand filters, heat pumps, salt-chlorinator cell unions, and general hydraulic pipework wherever a 1″ male BSP to 32 mm hose connection is specified.<\/p>","protected":false},"excerpt":{"rendered":"