Moteur monophasé Poolstar Freeflo Racer 0,75 kW - R0023

Poolstar Freeflo Racer single-phase motor 0.75 kW

This is the genuine Poolstar replacement motor for the Freeflo Racer filtration pump, rated at 0.75 kW on a single-phase supply. It is the component that drives the impeller and generates all hydraulic flow through the pump body — when it fails, the pump produces no flow at all.

Le rôle de ce moteur dans la Freeflo Racer

The motor shaft couples directly to the impeller inside the wet end, spinning it to draw water through the strainer basket and push it through the filter circuit. It is a TEFC (totally enclosed fan cooled) unit with thermal overload protection and built-in auto-reset, so it shuts down safely under fault conditions rather than burning out the windings. The IPX5 weather resistance rating means it withstands the poolside environment without additional housing.

À quels modèles Freeflo Racer est-il compatible ?

Reference R0023 covers the full single-phase Freeflo and Racer pump range: FFL-031, FFL-051, FFL-071, FFL-101, and FFL-151. If your pump is one of these model codes and is wired for single-phase mains, this is the correct motor. Verify your pump’s model code on the label before ordering — the Racer and Freeflo share the same motor mounting geometry across this range.

Signes indiquant qu'il faut le remplacer

The motor has failed when the pump hums but the impeller does not turn (capacitor or winding fault), when the thermal cutout trips repeatedly under normal load, or when the motor runs but produces significantly reduced flow due to bearing wear causing shaft drag. A burnt smell from the motor housing or visible scorching around the terminal cover are also definitive indicators. Do not attempt to restart a seized motor without first confirming the impeller turns freely by hand.

Pourquoi il est important d'opter pour des produits Poolstar d'origine

The motor mounting flange, shaft diameter, and electrical termination are all matched to OEM tolerances. Aftermarket motors marketed as compatible often differ on shaft length or flange bolt spacing, which causes misalignment between the shaft and impeller hub — producing noise, vibration, and premature seal failure. At 6.90 kg, this unit ships as a complete, ready-to-fit assembly with no additional adapter required.