Condensateur de fonctionnement pour pompe de filtration Poolstar Freeflo Racer, 20 µF, PPE – 0,55/0,75 kW - R0032

Poolstar Freeflo Racer filtration pump run capacitor 20µF PPE – 0.55/0.75 kW

This is the genuine Poolstar PPE run capacitor rated at 20µF, fitted to the single-phase AC induction motor inside the Freeflo Racer filtration pump in its 0.55 kW (¾ hp) and 0.75 kW (1 hp) configurations. It remains in the motor circuit continuously while the pump runs, sustaining the rotating magnetic field in the auxiliary winding and keeping the motor operating at correct efficiency.

What this run capacitor does in the Freeflo Racer

A permanent-split-capacitor motor uses a run capacitor — not a start capacitor — to energise the second-phase winding and create the rotating magnetic field the motor needs to turn. At 20µF, this component is sized precisely to the winding resistance of the Freeflo Racer 0.55/0.75 kW motor. Fit a capacitor of the wrong rating and the motor will run hot, draw excess current, or fail to reach full speed.

À quels modèles Freeflo Racer est-il compatible ?

This capacitor is confirmed for the Freeflo Racer filtration pump range in 0.55 kW and 0.75 kW output variants, covering model codes FFL-051, FFL-071, FFL-101, and FFL-151 where those power ratings apply. Always cross-reference your motor’s data plate before ordering — the capacitance value printed on the original component must match 20µF.

Signes indiquant qu'il faut le remplacer

The most reliable symptom of a failed run capacitor is a motor that hums continuously at startup but does not turn, or one that runs but trips the breaker after a short time under load. You may also see visible damage — a bulged or split capacitor casing, or traces of leakage around the terminals. Do not run the pump with a suspect capacitor: a failed unit left in circuit can overheat the motor windings and cause irreparable damage.

Comment l'installer

Isolate power at the breaker before opening the motor’s electrical end cover. The run capacitor is typically secured in a plastic cradle on the motor frame and connected by two spade terminals — note the orientation and terminal labels before disconnecting the old unit. Seat the replacement, reconnect the terminals, refit the cover, and restore power. The whole procedure takes around ten minutes with a flat-blade screwdriver.

Pourquoi il est important d'opter pour des produits Poolstar d'origine

Motor capacitors are safety-critical components: an under-rated unit will fail prematurely under sustained load, while an over-rated unit can overheat the windings. The genuine Poolstar PPE part is factory-specified at exactly 20µF to match the motor’s winding design, ensuring correct current phase shift and stable running temperature. Aftermarket alternatives may carry the same printed rating but vary significantly in actual capacitance.