This is the OEM cable holder (support for cable, 2010 platform) fitted to the Dolphin Supreme M5 and its close relatives. It clamps and routes the floating cable at the point where it enters the robot body, keeping the connection aligned and preventing strain on the cable connector during cleaning cycles.<\/p>\n
The cable holder locates the power cable against the motor unit cover, stopping it from twisting or pulling against the Amphenol-style connector during the robot’s climbs and turns. Without a secure holder, repeated cable movement works the connector loose, eventually causing intermittent power loss or water ingress at the entry point. This small part carries a disproportionate amount of responsibility for the reliability of the electrical connection.<\/p>\n
The 2010-platform cable holder is confirmed for the Supreme M4, Supreme M5, Supreme M400, Supreme M500, Liberty, Dolphin C3, Dolphin C4, Oasis Z5, Sigma, Triton PLUS, Wave 65, and Wave 90. All share the same 2010-generation motor unit cover geometry. Check your robot’s parts diagram under position 09 before ordering if you are unsure of your exact variant.<\/p>\n
Inspect the holder if you see the cable drooping or rotating freely against the robot body \u2014 it should sit snug with no play. A cracked, split, or deformed holder lets the cable swing and introduces bending stress at the connector root. In severe cases this leads to a broken conductor wire right at the entry point, an expensive fault that the holder is designed to prevent.<\/p>\n
No special tools are required. Remove the motor unit cover to access the cable entry area, unclip or unscrew the old holder, seat the replacement, and refit the cover. The job takes under ten minutes and does not require draining the pool or disconnecting any internal wiring.<\/p>","protected":false},"excerpt":{"rendered":"