Saltar al contenido

Pressure Pipe PVC-U 110mm × 4.2mm Glue Socket × Plain 10 bar PN10 Grey 5 m - 0309091

Bevo 0309091
Agotado
256,45  Impuestos Inc.
Certificado Certificado tienda en línea
Devoluciones fáciles Devoluciones fáciles dentro de 14 días
Pregunta ¿Buscas consejo?
Haz tu pregunta

Pressure Pipe PVC-U 110mm × 4.2mm Glue Socket × Plain 10 bar PN10 Grey 5 m

Rated to a full 10 bar working pressure and conforming to ISO 1452 PN10, this 110 mm outer-diameter PVC-U pipe with a 4.2 mm solid wall is one of the most widely specified large-bore pressure pipe sizes for pool plant rooms, pump headers, filter manifolds, and buried supply lines. Each length is 5 metres and arrives with one factory-formed glue socket at one end and a plain spigot at the other, ready to accept standard 110 mm solvent-cement fittings without additional adapters.

Material & pressure credentials

Unplasticised PVC-U is inherently corrosion-resistant, unaffected by pool chemicals, and carries an exceptionally smooth bore that keeps flow resistance low — particularly beneficial on the high-flow suction and return runs typical of commercial or large residential installations. The solid-wall construction and PN10 rating cover the pressures encountered in virtually all swimming-pool circulation systems.

Glue-socket jointing system

The integral solvent-cement socket at one end lets installers assemble runs quickly using standard PVC-U pressure fittings and PVC solvent cement. The plain spigot at the opposite end inserts directly into the next socket, creating a chemically fused joint that is permanently leak-free once cured. Lengths can be cut on site to suit any run length, and off-cuts retain the plain end for use with separate couplings.

Sizing & installation scope

At 110 mm, this pipe is suited to main circulation headers, backwash lines, and hydraulic connections between plant-room equipment in pools from roughly 100 m³ upward, as well as commercial sites where multiple pumps share a common manifold. The grey colour is the European convention for cold-water pressure duty, aiding identification in mixed-pipe plant rooms. Solvent-cementing requires standard personal protective equipment and adequate ventilation; cutting and jointing is achievable with hand tools.

Información adicional

Marca: Sin marca
Presión: 10 bar
Conexión: glue socket x plain
Material PVC-U (unplasticised PVC)
Diámetro exterior: 110 mm
Espesor de la pared: 4.2 mm
Longitud: 5 m
Presión nominal: 10 bar (PN10)
Estándar: ISO 1452
Tipo de conexión: Glue socket × plain (solvent-cement)
Color: Gris

En detalle

Pressure Pipe PVC-U 110mm × 4.2mm Glue Socket × Plain 10 bar PN10 Grey 5 m – 0309091
256,45 
  • Full 10 bar PN10 rating for pool plant-room pressures
  • Corrosion and chemical resistant — unaffected by pool water
  • Factory glue socket enables fast, permanent solvent-cement joints
  • Smooth bore minimises flow resistance on high-flow runs
  • 5 m lengths reduce joint count and speed up installation
  • Solvent-cement jointing requires ventilation and cure time
  • Large 110 mm bore makes on-site cutting less convenient without a pipe cutter