Tapa de rueda blanca Maytronics Dolphin Ex 10 S1/S2 - M96200033

Maytronics Dolphin Ex 10 white wheel cover S1/S2

This is the genuine Maytronics white wheel cover designed for the S1 and S2 drive-wheel assemblies of the Dolphin Ex 10 robotic pool cleaner. It clips over the outer face of the drive wheel, retaining the wheel on its axle stub while protecting the hub internals from pool-water grit and chemical ingress. As a direct OEM replacement, it restores the factory fit and finish of the robot’s drive system.

Función y papel en el sistema de transmisión

The wheel cover acts as the outermost retention and protection disc on each drive wheel. It locks the wheel laterally onto the motor-unit stub, prevents axial play during pool-floor and wall traversal, and shields the inner hub from abrasive debris that would otherwise accelerate bearing and gear wear. Without an intact cover, the wheel can work loose, causing erratic tracking and uneven cleaning paths.

Modelos Dolphin compatibles

This part is specified for the Maytronics Dolphin Ex 10 and fits both the S1 and S2 motor-unit variants used in that platform. Always cross-reference your motor-unit designation (S1 or S2) before ordering, as wheel covers for other Dolphin chassis lines differ in diameter and clip geometry.

Síntomas que indican que es necesario un reemplazo

Replace this cover if you notice a drive wheel wobbling or riding off-centre on the pool floor, if the cover is visibly cracked, chipped, or missing, or if the robot pulls consistently to one side despite clean tracks and intact tyres. A damaged cover that allows lateral wheel movement will cause accelerated wear on the wheel hub and motor-unit shaft.

Por qué es importante utilizar recambios originales de Maytronics

Aftermarket wheel covers for Dolphin robots are frequently moulded in inferior plastics that become brittle under UV exposure and pool chemicals, leading to premature failure. The genuine Maytronics part is manufactured to the original dimensional tolerances, ensuring a secure snap-fit and the correct retention force. Using genuine parts also preserves any remaining Maytronics service warranty on the robot.