Maytronics - Dolphin diagnostic cable basic 18m with connection (no swivel) for Acapoolco, Baly, DB4 O'Clair, Facil'O, Ozeo, Zyke - 9995851-DIY

Maytronics Dolphin diagnostic cable basic 18m with connection (no swivel) for Acapoolco, Baly, DB4 O’Clair, Facil’O, Ozeo, Zyke

This is the genuine Maytronics OEM 18-metre diagnostic cable (DIY finish) for the Dolphin EasyKleen family of robotic pool cleaners. It carries low-voltage power and control signals between the power supply unit and the cleaner’s motor block, and its pre-moulded plug on the motor end allows a direct, tool-free connection at the robot’s cable port.

What this diagnostic cable does in the Dolphin

The cable is the sole electrical link between the transformer/PSU on the pool deck and the drive electronics inside the cleaner. A failed or damaged cable stops all movement and prevents the PSU from running its diagnostic cycle. This 18m length is the standard reach for residential pools up to roughly 10 × 5 m, keeping the cable clear of the cleaner’s tracks without excess slack that can tangle.

¿Con qué modelos de Dolphin es compatible?

This cable is confirmed for the Dolphin Acapoolco, Baly, DB4 O’Clair, Facil’O, Ozeo, and Zyke — all members of the EasyKleen/Nauty-TC platform (Maytronics model references 99996041, 99996042, 99996044, 99996046, 99996049, 99996051, 99996056). Cross-check your model number printed on the cleaner’s label before ordering, as this cable shares the platform with several closely related variants.

Señales de que hay que cambiarlo

The cleaner stops mid-cycle or fails to start, yet the PSU shows a fault code pointing to an open circuit rather than a motor fault — that is the primary indicator. Inspect the cable along its full length for kinks, crush damage near the swivel entry, or corrosion at the moulded plug. A cracked outer jacket that lets water wick into the conductors will also cause intermittent cut-outs that worsen over time.

Cómo instalarlo

Unplug the PSU from the mains before touching any connection. Disconnect the old cable at the robot’s top port by pressing the locking tab and pulling the moulded plug straight out. Feed the new cable through the same routing clips on the handle, push the moulded plug firmly into the port until it clicks, then reconnect the PSU end. The entire swap takes under five minutes and requires no tools.

Por qué es importante que los productos de Maytronics sean originales

Dolphin power supplies communicate with the cleaner through the cable’s conductors using proprietary signalling; an incorrect wire gauge or non-OEM insulation rating can corrupt that signal and trigger false fault codes, or in worst cases damage the PSU transformer. The genuine 9995851-DIY cable is built to Maytronics’ conductor and insulation specification, ensuring the diagnostic handshake between PSU and motor block works exactly as designed.