Maytronics Dolphin C6 CB cable update - 14949R5042

Maytronics Dolphin C6 CB cable update

This is the genuine Maytronics cable update part for the Dolphin C6 CB robotic pool cleaner — a short replacement cable segment designed to upgrade or renew the internal cable connection between the robot’s motor and the swivel assembly. It allows technicians to restore correct electrical continuity at the swivel junction without replacing the entire main floating cable.

What the cable update does

The cable update replaces the short section of cable that runs from the robot’s motor to the swivel. Over time, repeated flexing and chemical exposure can degrade this segment, causing intermittent power loss or failure to respond. Fitting this update cable restores full electrical continuity and, where applicable, converts an older assembled-plug (ASSY) connection to the current DIY molded-plug standard.

Compatible model

This part is listed specifically for the Maytronics Dolphin C6 CB. Always verify against your robot’s serial number and parts schematic before ordering — the C6 CB uses a specific connector and spring type that must be matched exactly.

Symptoms that indicate replacement is needed

Common signs that the cable update is required include the robot cutting out intermittently during a cleaning cycle, the power supply showing a fault code despite the main cable appearing undamaged, visible fraying or kinking of the short cable section close to the robot’s cable entry point, or failure of the swivel to rotate freely because worn internal wiring is binding the mechanism.

Why genuine Maytronics matters

The internal wiring of a Dolphin robot carries low-voltage DC power and communication signals between the power supply and the motor unit. Maytronics genuine parts are manufactured to the exact gauge, insulation rating and connector geometry required for the C6 CB. Third-party cables frequently use undersized conductors or non-compatible connectors that can cause signal errors, void the warranty, or create a safety risk at the waterproof cable entry seal.