This is the OEM plastic fan cover (shroud) that fits over the external cooling fan on the rear of the Poolstar Freeflo filtration pump motor. It channels airflow across the motor casing on the TEFC (Totally Enclosed Fan Cooled) motor, keeping the motor at a safe operating temperature during continuous filtration cycles. One cover serves the 0.55 kW, 0.75 kW, and 1.10 kW single-phase pump variants.<\/p>\n
The Freeflo uses a TEFC motor design in which an external fan \u2014 not internal airflow \u2014 cools the motor body. The fan cover encloses that fan, directing air over the motor housing to dissipate heat and protecting the rotating fan blades from poolside debris, hose splashes, and physical contact. Without an intact cover, cooling airflow becomes uncontrolled and the fan itself is exposed to damage.<\/p>\n
This cover is confirmed for the Poolstar Freeflo filtration pump range in the three single-phase power ratings listed: 0.55 kW (0.75 hp), 0.75 kW (1 hp), and 1.10 kW (1.5 hp). All three share the same rear-motor geometry, so a single cover part covers the full range. Verify your pump’s kW rating on the motor data label before ordering if you are unsure of your model.<\/p>\n
Inspect the cover when you service the pump at the start of each season. A cracked, shattered, or missing fan cover exposes the spinning fan blades \u2014 a contact hazard \u2014 and allows uncontrolled airflow that reduces cooling efficiency, shortening motor life. You may also notice the motor running hotter than usual or see visible plastic fragments near the pump base after an impact.<\/p>\n
Isolate the pump from power at the breaker before starting. The cover typically clips or screws directly onto the rear motor bracket; remove any retaining screws or clips, pull the old cover away from the motor end, align the replacement over the fan, and refit the fixings. No special tools are required beyond a screwdriver, and the job takes under 10 minutes on a cold pump.<\/p>","protected":false},"excerpt":{"rendered":"