Maytronics - Conjunt de cable i giratori Dolphin EasyKleen de 1,2 m per a diagnòstic (bricolatge) - 9995793-RC-DIY

Maytronics Dolphin EasyKleen cable and swivel assembly 1.2m diagnostic (DIY)

This is the genuine Maytronics replacement cable and swivel assembly for the Dolphin EasyKleen, measuring 1.2 metres in length. It connects the robot body to the power supply, carrying the diagnostic signal that allows the unit’s control circuit to communicate operational status. The DIY designation means the motor-end plug is factory-moulded directly onto the cable, so you route it through the grommet above the support bracket and push it straight into the motor socket — no retrofit kit required.

What this cable and swivel assembly does in the Dolphin

The swivel joint sits at the point where the cable exits the robot body. It rotates freely as the cleaner changes direction, preventing the cable from twisting back on itself and reducing fatigue on the conductor cores over time. On the diagnostic range, the cable also carries the low-voltage signal wire that feeds fault data back to the power supply; a damaged or water-ingressed cable breaks that circuit and typically triggers a no-start or error condition on the PSU.

Senyals que cal substituir-lo

Visible jacket cracking, kinking, or white mineral deposits along the cable run are the clearest indicators. If the robot starts briefly then stops, or the power supply displays a short-circuit or motor-fault code that clears when the cable is unplugged, the cable assembly is the first component to swap out. Check the grommet entry point carefully — this is where water ingress most commonly begins on this design.

Com instal·lar-lo

Feed the free end of the new cable through the grommet above the support bracket until the grommet seats flush with the panel. The DIY-style moulded plug then connects directly to the motor terminal inside the robot — it only fits one way. Re-seat the grommet firmly to restore the water seal, then run a short test cycle to confirm the diagnostic signal is clean before returning the unit to service.

Per què Maytronics és important

Aftermarket cables for the diagnostic range frequently use undersized conductor cross-sections and softer jacket compounds that crack prematurely under UV and pool-chemical exposure. The genuine Maytronics assembly uses a 2-wire rubber-spring construction rated for continuous wet-environment use, and the moulded plug maintains the correct pin geometry to preserve the diagnostic signal integrity. A mismatched plug can damage the motor-board terminal, turning a cable swap into a motor-unit replacement.