Flotide/MEGA - Interruptor de baixa pressió 0,2–0,35 MPa (Bomba de calor inversora Xp05Csie) - 7024792

Flotide/MEGA – Low Pressure Switch 0.2–0.35 MPa (Inverter Heat Pump Xp05Csie)

This is the genuine Flotide/MEGA replacement low pressure switch for the Flotide/MEGA Inverter Heat Pump (Type Xp05Csie). Mounted on the suction side of the refrigerant circuit, it continuously monitors low-side pressure and automatically cuts out the compressor if pressure drops below the safe operating threshold, protecting against refrigerant loss, coil freeze-up, and costly compressor damage.

Com funciona

The switch operates within a calibrated range of 0.2–0.35 MPa. When suction-side refrigerant pressure falls below the cut-out point — signalling a potential refrigerant leak, restricted metering device, or loss of charge — the switch opens the compressor control circuit, halting operation before damage can occur. Once normal pressure is restored, the switch resets automatically.

Compatibilitat

This low pressure switch is a factory-specified spare part for the Flotide/MEGA Inverter Heat Pump, Type Xp05Csie. Always verify your heat pump’s model and existing switch specification against the 0.2–0.35 MPa pressure range before ordering. If you are unsure whether this part matches your unit, contact us with your full model number for confirmation.

Per què l'autenticitat importa

Using a genuine Flotide/MEGA pressure switch ensures the correct pressure thresholds, electrical ratings, and connector fit for your heat pump. An incorrectly rated switch may fail to protect the compressor at the right pressure point, potentially voiding your warranty and leading to expensive repair bills. Replacing a faulty switch promptly is one of the most cost-effective ways to safeguard the compressor — the single most expensive component in the heat pump.